Thread: steering question
Hybrid View
-
04-13-2009 11:54 AM #1
Funny you mention that. I painted my shafts and then the one wouldn't fit through my support bearing, so I sanded it down and put it on. Might have to brush paint it.
Sean
-
04-13-2009 12:37 PM #2
My GM column has splined out put and my MII rack has splined input, but not the same diameters. I will likely convert over to a double D sectional one day but no plans at this time. Cost is usually no different between splined shafts or double D's. Stainless is a lot more expensive than steel for everything, shaft, u joints, supports, vibration dampers etc.
As volksrod said the advantage of the double d is being able to cut to size. With the splined units it's like carpentry...... measure many times, cut once.
I have seen vibration dampers in use, but I don't have one on my car and don't think I have a real need for one either. I know Borgeson has everything in steel or stainless, but I thought Flaming River did as well, but I see that they now only offer stainless and aluminum.
Mine had Mil-Spec universals for years and never had any problems even though they are not street intended. Good enough for airplanes and drag cars, but not for street rods.Bob
A good friend will come and bail you out of jail....but a true friend will be sitting next to you saying..."Damn....that was fun!
-
04-13-2009 12:55 PM #3
I wish I had money to just buy stainless and be done with it so I don't have to try and paint and have it not fit.
so when cutting a splined shaft can you simply cut it off with a cut off wheel and then clean it up?
thank you all'35 Ford coupe- LT1/T56, '32 Ford pickup, 70 GTO convertible, 06 GTO
Robert
-
04-13-2009 07:46 PM #4
Double D shafts look too agricultural for my tastes, though they do have the advantages Walt and Bob mentioned. A slight advantage to the spined shafts is you have slightly more clocking ability for alignment of the column, steering wheel setup. Most of the quality spined shafts have 2 inches of spine at each end. I buy one as close to two inches longer than needed as possible and cut off the extra from each end which minimizes the amount of exposed spine sticking out from the joints (again a cosmetic issue, but details make the difference on hand built cars). Cutting off with a cutoff saw should give you a nice even cut, just grind a slight bevel on the cut ends, makes it slide into the joints more easily. Also plan to counter sink a set point where each of the set screws hits the shaft, gives a more secure set.Your Uncle Bob, Senior Geezer Curmudgeon
It's much easier to promise someone a "free" ride on the wagon than to urge them to pull it.
Luck occurs when preparation and opportunity converge.
John's ride to the cemetery, his beloved Billings OK bus, The Baby Elephant!! Traveling in style!! - -
John Norton aka johnboy