Thread: Mounting Rear License Plate

Tweet

Originally Posted by bucs012

So I DO just drill through the rear panel to mount it?

IC2- I did see those holders from Speedway, but my gas tank is only about the width of a toothpick, off my spreader bar.......Speedway told me their brackets are about 3/8 of an inch thick so the license plate holder would not fit. I must have an extra thick rear spreader bar at 2"..........

In that case, get some nutserts like these from McMaster Carr(page 3213), install them in some holes you drill in your speader bar, buy the Speedway version, discard the back side, drill and countersink some holes on the plate side, and screw into place with a couple of flathead machine screws or make up some brackets out of aluminum plate stock. No big deal

These are the before and after drawings of the nutserts.

(Oh, rear spreader bars for '32 Fords are normally 2" diameter)