Thread: fiberglass frontend

Tweet

I don't have any pix for ya so I had to go look around.
http://www.autofab.com/hoodpins.htm if you look at the last two pix you should get the idea, might be able to build your own , I don't know if your a kit guy or not, so good luck.
I've seen some that look like there is a giant dead spider laying under the engine w/ all 8 legs sticking straight up and out 4 should be plenty but some have more.

just SeaRch for hood pins , because no one else knows what to call them either .

Only thing I can tell you is the easier it is to get to the pull pins now the more you'll like it later & make sure they are spring loaded for stress to the one piece (and the spring will keep the slip pin tight ) and ease of removal later. maybe some one else has better pix handy .
Or a fancier way i haven't seen ?

Have seen where some of the guys rig small funnels on the underside to make install much quicker , you know bigger hole less time trying to get it in, then you get it close and she slips right on.




T L