Thread: fiberglass frontend

Tweet

sorry it took so long to reply. I was going to get a one piece from VFNFIBERGLASS. I don't need it to tilt, I was wondering if the piece is stong enough to span from the firewall to the core support or do I need to reinfoce it? and can you mount it like you would normal fenders. just use the same holes in the core support and car?

If the piece isn't strong enough to span that length I wouldn't buy it, so no you shouldn't have to reinforce it , if your a fan of over kill x3 then ya, by all means slap some straps in it and slather them over . but most of the ones I've delt with have been plenty thick but i've never delt w/this company .

and yes you can just bolt it to the same holes "if that's what your asking ? " there should be a few that will lay where you can get to them . but do you want to crawl under there every time to pull it off ? or is the whole point to make it look stock w/no showing pins ?

your not bolting it up are you ? that would suck to take all of them out when you need in there ?

hope that helps
T L