Search:

went thought the rear-end yesterday, everything looked good the backlash and the contact pattern, this being the first chevy rearend i have done i called a few local racer and got there thoughts, so...

will this must be the wrong crush sleeve, i know from all the chysler `s i have done mostly 8 3/4`s , you use around 170ftlbs and the 8 1/4`s you end up with 120 ftlbs, if the prober drag i seen on...

just back from checking the rear end , i didn`t remover the cover put removed the drive shaft and rotated the pinion, the backlash felt good but the pinion had a hard feel to it not like when i...

i did do all my measurement with old bearings that were reamed out so they could be slipped on and off to get the right shim #`s on the pinion, then when all the measurements were good i pressed the...

just installed a 4.10 gearset in a GM 10bolt axle, trans am for a friend, backlash set at .007 and contact pattern smooth and across the gear tooth face about 3/16in up from bottom of tooth,with 2lbs...