Search:
Type: Posts; User: shawnlee28
-
05-04-2008 10:57 PM
Thread: richmond gears
by shawnlee28- Replies
- 9
- Views
- 2,555
My old and new bearing were 2 different sizes...
My old and new bearing were 2 different sizes ,meaning the honed out bearing gave a different backlash and pinion depth than the new one needed...........and it takes alot of torque to crush that...
-
05-03-2008 09:50 PM
Thread: richmond gears
by shawnlee28- Replies
- 9
- Views
- 2,555
I would do the entire check list over again,check...
I would do the entire check list over again,check backlash ,rear cap torque,...etc....:confused:
I remember the pinion bearing preload ,rotational force setting was in inch pounds on...
Moving on to next phase of frame reconstruction . Due to the Trans location I need to build a new center section for the X member. 1st cuts have been made . [/URL] I will use this 6"dia. ...
New Project