Search:
Type: Posts; User: camaro_fever68
-
06-24-2006 07:49 PM
Thread: How do i get 400 hp from a 355?
by camaro_fever68- Replies
- 23
- Views
- 29,292
Straight out the gate today we turned a 12.10 ET...
Straight out the gate today we turned a 12.10 ET at 112mph. Dropped the jet's down a size in front and rear and run a 11.97 at 112 also. 60ft wasn't doing so well with a 1.63 best of the two runs. ...
-
06-24-2006 07:40 PM
Thread: How do i get 400 hp from a 355?
by camaro_fever68- Replies
- 23
- Views
- 29,292
It would make peak torque and hp lower in the...
It would make peak torque and hp lower in the band with 274 but will cost the average hp and torque numbers. The 274 will also bring the dynamic CR to almost 8.6 and it's getting pretty tuff to find...
-
06-23-2006 11:23 PM
Thread: How do i get 400 hp from a 355?
by camaro_fever68- Replies
- 23
- Views
- 29,292
At 3K, which is where the dyno started loading, ...
At 3K, which is where the dyno started loading, it had over 350ft/lbs and by 3400 it was over 400ft/lbs and didn't fall below 400ft/lbs until after 5300. Will be at the track tomorrow to see what...
-
06-23-2006 10:22 PM
Thread: How do i get 400 hp from a 355?
by camaro_fever68- Replies
- 23
- Views
- 29,292
Plenty money = Start from scratch 1. ...
Plenty money = Start from scratch
1. Rotating Assembly
356-B13005L+040 SB-Chevy 383ci Street & Strip Rotating Assembly, .040'' Overbore
Bore x Stroke: 4.040'' x 3.750''
Rod Length: 5.700''...
Moving on to next phase of frame reconstruction . Due to the Trans location I need to build a new center section for the X member. 1st cuts have been made . [/URL] I will use this 6"dia. ...
New Project