Thread: Rat rod frame suggestions

Tweet

Originally Posted by dmw56

I'm not familiar with the axle set up on the big trucks but if it's similar to the car axles you might be able to get a spindle kit from Speedway motors that will accept GM disk rotors.

As far as the Camino as a donor you should be able to use a lot of parts off of it. The rear may be a little wide but with the right offset wheel it should work. You can certainly use the trailing arm coils spring set up.

Thanks dmw56 and evryone else that has contributed to this thread. You all have been very helpful. I'm sure I will have more questions in the near future.
Tom