I put in a Painless wiring kit in my model a hiboy hot rod, and I added a push button starter switch to turn the 350 chevy motor over.
I need to know how to wire up my starting circuit right, by seeing a schematic showing how the keyed amkt starter switch I'm using should be wired for this addition of the push button. Also need to know how to check to see if, while engine is cranking, that the "on" (or Ignition side) circuit is still "on" and not cut off during engine cranking. I ran a wire direct from the + coil terminal back to the "I" terminal on the Ford type remote solenoid I am running with a rear mounted battery set up. I am running a pertronix set up in a recurved OE distributor. Any help or a link to a diagram would sure be appreciated. I need this answered before I touch 12volts to it. Thanks.