Thread: 34 3 Window Re-Build

Tweet

Jeeezz Bob,

Now I have another word to look up. Thanks.

Jack.

Started some work on the gas tank cover. When I bought the coupe the gas tank cover was one of the few pieces not included so I bought a glass one. Still have the glass one but I wanted the all steel coupe to be "all steel" so I bought this steel one for $25 a few years ago and it needs some work. Did I mention that I'm a tight wad. Here are a few pics of what I have done so far. The patch is a little tricky as the parent metal is a little thin. I Tiged the patch in but I think I will try to Mig the final weld as I think a steady stream of filler wire will help me with the thin metal. Any opinions welcome before the final weld. Also added some wall art pics. Anybody from Sacto know anything about the Pushrods?

Hiya Jack, heck a gennie steel '34 coupe,you lucky thing. It should be sharing garage space in my garage, yeah right. I would continue with the tig as I find the mig leaves too much of a buildup of wire which is hard so that one ends up grinding away which also results in grinding away the original steel,IMHO. Can the panel be reinforced somehow where the bumpers bolt through the chassis??

Cool pics Jack, where`d you get the sacramento plaque from....?

Whiplash,

Thanks for the comment. I have thought of making the patch out of thicker material (.1875) but I was afraid that would push the cover too far away from the bumper bracket causing some panel or seam misalignment. However, at your suggestion, I think if I just double the thickness of the sheet metal (.050-.060) it won't be too much of a problem. I also might try O/A for the final weld as I think I can control the heat better with that.

Rich,

My father in law had that plaque hanging on his garage wall and I aquired it after his death. Don't know for sure but I think he picked it up during summer recess when he was a janitor at Hillsdale H.S. in San Mateo, Ca. He had some good stories about what the kids left behind in their lockers after school let out.

Jack.

As you may already know, that stress cracking comes about because of misalignment of the bumper bracket mounts on the rear spreader bar under that tank cover. Rather than mess with trying to fortify the cover I'd suggest you work at bending the tabs on the spreader bar so they are nearly right up against the back side of where you patched, I say nearly because I like to put some antisqeak material in there too. If the spacing can't be tightened up without a bunch of modification to the under brackets then some shimming might be necessary. It can be fun to get the bumper mounted straight on those sometimes.

The plaque looks like one of the local car clubs type. I see them on the back of hot rods around here from time to time.