Got a little bit of work done today.
The exhaust did not get into my hands until today which I was hopping I would get yesterday. I had to cut and weld the tubing until it sat above the bottom of the frame rail and into the cut out in the crossmember. Just managed to get the drivers side done today, the passenger side will be more work. Either I have to cut and weld a lot on the tubing because of the heat riser on the pass. manifold or I will bevel the manifold so the gasket will seal.
What I started with

After cutting and welding, might be a bit restrictive but it looks better than exhaust hanging down below the frame

Not a fan of glasspacks but they fit better than chambered mufflers