Hybrid View
-
04-20-2008 05:15 PM #1
Roadster Pickup comes home on the Hook!!!
Well, I suppose its inevitable.---If you drive a hotrod for enough years, sooner or later, its going to let you down. Yesterday, I was out, cruising all over town with that big cheesy grin that the first springtime ride will give you. Today I was installing a window air conditioner for my stepson who lives on the far side of town in a small apartment with his wife and my two grand daughters. First trip over to measure the window opening---everything went fine---Second trip over to trial fit the thing--trip over went fine. When I left his place, the RPU hiccupped when I left his steep driveway---I thought--Hmmm---Must be flooded a bit from being parked in a real steep incline. It seemed to clear allright, and I drove down to the first intersection. Then it quit!!! I could smell gas quite strong, and it turned over fine, but no spark. I waited 15 minutes and tried again---same thing. Two kids about 30 come along and were admiring the car, so I got them to help me push it into a parking spot and left it there. Caught a ride home and got my Ford Ranger and my towbar that I built 4 years ago when I was dragging the car around for muffler work, etcetera, and went back across town and hooked up the car and towed it home. Waited an hour and tried to start it again. This time, it wouldn't turn over at all. Charged the battery for 2 hours---got lots of horn (no lights on it right now, waiting for Halogens), and it still won't turn over. I hear the sarter solenoid kick in, then just a grunt, and nothing else!!! Now I guess that tomorrow I will get to see if the "drop out" battery box that I built and then installed under the bed floor BEFORE I built the bed floor will really "drop out". Its acting like I may have a bad connection at the battery.---Or a bad ground. I got my sons fishing boat battery out of the shed and put the charger on it, so tomorrow I can try and figure out what the heck is going on.Old guy hot rodder
-
04-20-2008 06:36 PM #2
Brian, I think I would maybe pull the plugs and make sure the engine isn't hydrauliced before you try to turn it over again (or at least put a wrench on the crank bolt and make sure it turns).I've NEVER seen a car come from the factory that couldn't be improved.....
-
04-20-2008 06:52 PM #3
I believe I'd be looking at the starter and solenoid first off.Ken Thomas
NoT FaDe AwaY and the music didn't die
The simplest road is usually the last one sought
Wild Willie & AA/FA's The greatest show in drag racing
-
04-20-2008 08:21 PM #4
I had the same thoughts as Mike P about the water in the cylinders. Maybe a head gasket, but I hope just a bad connection for your sake Brian.
Don
-
04-21-2008 07:34 AM #5
Any chance a positive battery cable is lying on a sharp edge?
Or the main supply wire - usually 10 gage - doing the same?
That ones caught more than a few.C9
-
04-21-2008 09:51 AM #6
Went out early this morning and tried the starter---no joy!!! Just a grunt. Worked all morning on computer--ran out at lunch hour and pulled the plugs. Engine was totally hydrauliced!!---With gasoline. I pulled the passenger side rear plug, and gasoline ran out of the cylinder. That is the first time that has ever happened to me. After getting a good visual on where my fire extinguisher was, I tried the key---all plugs out. It shot gasoline clear across the garage!!! Now, back to work for the afternoon and do some more on the RPU tonight. I'm still convinced it had something to do with parking in that real steep driveway for half an hour.--Darned old intake must have been right full of gasoline. I'm just surprised that it started and ran for 3 or 400 yards before it died at the stop sign!!!Old guy hot rodder
-
04-21-2008 10:23 AM #7
Good call MikeP!1930 A Bone
-
04-21-2008 10:27 AM #8
Probably what happened was that on that incline your needle(s) didn't seat and gas kept flowing until it filled the engine with gas. Hope you didn't bend any pushrods from the engine trying to turn over.
Don
-
04-21-2008 11:00 AM #9
Denny---I do have a pressure release cap, and Don--I don't think I bent anything---the engine did start and run for about 4 or 5 minutes before it quit for good.Old guy hot rodder
-
04-21-2008 12:09 PM #10
What carb are you running?
The angle of the dangle must have been such that as said above the needle and seat did not work right or it allowed fuel to run freely into the carb depending on model.
I calculate 225 inches of head required to get to 6 psi which is why I would also say it is in the carb. If parked with the tank up you could siphon the tank into the carb. Like Denny says, with tank down you might still drain a bowl into the manifold.
KitzJon Kitzmiller, MSME, PhD EE, 32 Ford Hiboy Roadster, Cornhusker frame, Heidts IFS/IRS, 3.50 Posi, Lone Star body, Lone Star/Kitz internal frame, ZZ502/550, TH400
-
04-21-2008 03:04 PM #11
Damn damn, and damn. I went out right after work, put the plugs back in, went down to the corner store to buy a quart of oil, and when I got back it had hydrauliced again!!! More investigation will follow. How friggin much gasoline can one small block intake hold???? Now I will have to investigate which is higher---carb or fuel tank. If the float needle sticks open, will it gravity feed thru a mechanical fuel pump?Old guy hot rodder
-
04-21-2008 04:08 PM #12
Wierd Brian. I had a Makuni carb that would constantly overflow. Sent it back to them and they found microscopic glass beads in it that caused the float to stay open. These things can drive you crazy! Steve." "No matter where you go, there you are!" Steve.
-
04-21-2008 04:17 PM #13
Originally Posted by brianrupnowYou don't know what you've got til it's gone
Matt's 1951 Chevy Fleetline- Driver
1967 Ford Falcon- Sold
1930's styled hand built ratrod project
1974 Volkswagen Super Beetle Wolfsburg Edition- sold
-
04-21-2008 05:05 PM #14
Brian I can not recommend strongly enough that before you attempt to start the RPU again that you drain and change the oil and filter. By now you probably have a crankcase full of gas.......2 worst case seneiros that I have personally seen th results of are a crankcase explosion (severe enough to literally blow the valve covers off a SB Mopar) and/or wiped bearing.
Yes it can siphon and dribble out the venturies once the level gets high enough (the vent tube is higher so you won;t see it come out of there).
One cure that I have used in the past if the tank is higher than the carb is to run an electric inline fuel valve. Once power is supplied (key in the on position/start position) the valve opens. With the key off it defaults to the closed position.I've NEVER seen a car come from the factory that couldn't be improved.....
-
04-21-2008 05:26 PM #15
Originally Posted by Mike POld guy hot rodder
The main function of your little toe is to make sure all the furniture in the house is in the right place.
the Official CHR joke page duel