Here is the new pressure switch housing proto-type just off the mill. This protects the switch from moisture and debris and looks good doing it. I do not have the sealed port for the wire in yet. It will come out the back. Once I get the screws for the cover I will install it on the truck and take a couple of pics. This will be finished (some edges rounded over, finish mill pass here and there)and polished before final install on the truck.IMG_2738-1_zpszecrwwzc.jpgIMG_2743-1_zpse1xkhlpa.jpgIMG_2745-1_zpsvstexcmy.jpg