Heres the start. A/C compressor mounted too far outside. Hood bonnet wont clear without mods, so some different brackets are in order.
http://i41.tinypic.com/nzo8jo.jpg
Started off hangin the compress where I thought it should go, then I made some templates out of paper:
http://i40.tinypic.com/14mcnk.jpg
Some tracin, a little torch work and lots of grinding:
http://i41.tinypic.com/2utrjmh.jpg
Using some 1/2 sch. 40 pipe, I cut a few pieces and mounted them to the block using all-thread. The holes in the a/c, & alt. plates are large enough so the plates are adjustable as to set the correct spacing with aligning the belt.
http://i44.tinypic.com/6emanq.jpg