Finally got back to the chassis work.
I made up a couple of rad support posts and two outriggers to mount the new front clip on.
I welded two tabs at the top of the support posts and bolted two tabs to the bottom of the frame rails for the radiator isolators to bolt on to.




I finally got the new (used) mill running and machined out the tabs for the rad.
These will bolt to two 1/4'' aluminum side plates. The plates will then be welded to the rad to spread the load rather than just having the tabs welded to the sides of the rad.










Rubber isolators I found on line.
They are good for 55LBS each in shear.






Thanks for looking,