Thread: 41 New Yorker Coupe

Tweet

Originally Posted by Mr Blue

That Cobra IFS throws this project over the top! Amazing fabrication skills. Just WOW!
Don Jr.

Hey Don, Throw in a few extra WOW's for me, too!! I can only dream of those kinds of skills!!

Thanks Guys.


The next step was to get my total front end geometry correct.

I got a program online and started the task of getting the roll center as low as possible and everthing lined up using the spindles I had.





Its a pretty good program as I could go thru dive and roll and see the results.
This enabled me to check all the pivot points for the upper and lower control arms, length of arms, etc.