Here's one of the wheels fitted, ignore the fact i put the springs back on the wrong way round , the pins are off set and i didnt notice till it was back on the ground.

Fitting the spindle mounts did exactly what i wanted by moving the wheel inboard a few inches, the old wheels were pushed out by the adaptor in the disc kit and the answer would of been to narrow the axle slightly.

Today i took the wheel to an expert, he was a really nice bloke and even let me have a go on a scrap magnesium rim, Its very much like welding ally, except the gas mix is 50/50 argon/helium and the rod is obviously different, we used a az101 filler rod. The arc is also much shorter than aluminium and everything has to be very very clean. Also he preheated it.
I learn't a lot of this old guy today and now would'nt hesitate to have a go myself.
Unfortunately he didn't finis the job as he ran out of rods








.