Been looking around for door handles & window winders but couldn't find anything suitable so decided to make some, found some offcuts of 1" round stainless and a few bits of 3/16" stainless plate, These are similair to my 26T handles but more simple which fits in with the car.

First job was to turn up and bore out the 1" bar for the handle bases.








Next i needed to get the hole square to match the square shafts, a bit of 2mm stainless sheet was cut up and folded round a bit of square bar, then the joint was welded.








Next the square tube was pressed into the bored out are of the handle bases.








Next job was to weld them in. Then they went back in the lathe to be faced off.












Heres the handles finished, they just need polishing to finish.






:cheers: