Thread: Picked up some GT 40 P heads

Tweet

Would work bring the exhaust ports down in the front of firewall.

The cheapy Mustang headers would need a lot of work to direct the exhaust correctly in an 'A' - I tried it!!!! Then spent the bucks for some uncoated Sanderson's, cleaned up their mistakes in the gas path then had them Jet Hot coated rather then some vendor's unknown quality coating that Sanderson uses.



Bobby - that photo will give you some idea of where the motor mounts are as far as height.

and the other side....

Thanks Dave again the Sandersons are about the only candidate that will work easily

Originally Posted by bluestang67

Thanks Dave again the Sandersons are about the only candidate that will work easily

Bobby, I think it also depends on where you intend to run the exhaust pipes rearward....will you route them through the X-member or under it? I have the Sanderson headers for mine too but I haven't completely decided the path for the exhaust.....

Hey guys just got out of hospital last night . Ticker was tocking a little will say angiogram's really suck .


Randy really far from that Idea yet . just received everything to get the flatty fired to sell it . Then all the suspension has to go .