I found this engine from a guy I know and he is pretty good guy. He's willing to give me this for $700 plus some parts that he could use that I don't need. I want to try and run my Edelbrock 600 carb on it and I'll need an intake. It's going on my '31 Model A Streetrod that I've been working on(before it was a '27 T Sedan ). I'm looking for opinions on what I could do with it without spending too much more money, and what tranny I should look for. I'll tie it into a Chevy 12 bolt rear end cause I already have the brackets welded on. Just don't want to have to buy a blower. Maybe a new cam though.

For sale ; 5.0 L complete engine spec'd for a blower

The engine has about 950 km on it.

Aluminum Trick Flow High Port heads, DSS forged 1.600/4.030/ - 13 cc low compression inline pro series pistons. Custom grind cam from flowtech induction ( part # SC1934-HR112 )
lift 1.6 ratio , intake .5632", exhaust .5664" , lobe seperation 112 degrees. , Aluminum roller rockers 1.6 ratio, powerbond balancer, Ford Explorer upper and lower intake.

I'll try to get more info.

Thanks,
Sean.