Thread: Helping a Brother in Need...

Tweet

you need to check and see if you have any codes in your computor. you can do this by jumping the A and B wires in the DLC. the dlc is located under the dash on the drivers side. give me the codes and i can tell you what it is.


Locate Data Link Connector (DLC), see image below.
Jump the A&B terminals(a paper clip or a jumper wire work ok)
Turn Ignition switch to ON position.
Count the flashes on the "CHECK ENGINE" or "SERVICE ENGINE" light.
FLASH, pause, FLASH, FLASH = code 12
NOTE: Some 94 & 95 models do not have the B terminal. In which case a scanner is required.

All vehicles after 96 are OBDII,and require a scanner to access hink of.... [/B][/QUOTE]

dont make fun of my drawing eather