Thread: P-30 Truck/RV/Motor home Chevy 454 question

Tweet

Originally Posted by madscotsman59

So the next big job is building a straight lift arm to weld onto my engine lift to squeeze it out of the front grill.

You're going to want to be careful with that approach! That BBC weighs in between 650 and 685 pounds dry weight which is going to be just below the fully extended capacity of most roll around hoists. Mine has a 2 ton capacity boom short, and for each 9.5" you extend the boom you lose 1/2 ton - 2T, 1.5T, 1T, then 0.5T (1000#) fully extended. Plus if you extend the boom you need to extend the bottom supports to reach at least to center mass of the engine or you'll flip it forward. Your hydraulic cylinder is going to be exceeding capacity, and you're looking at a train wreck, IMO.

I would think that the hoist, boom extended to the 1/2T point would be long enough to put the hook over the carb. If not, do you have a friend with a tractor and a rear boom pole lift? Most newer ones are 1000# capacity mounted on the rear 3-point hitch.

Yea i knew about the capacity issues, i have a sliding rail system i built for something else to rest the mounts on once i get it lifted 2 inches, then i can just slide it right out then pick the whole thing up with my tractor bucket. I Just have to find two pieces of 3x3 or 4x4 square stock tubing to tack on the rail bed. Safety first. Learned that working in a shipyard and watching two men die over someone else's carelessness.