O.K. Really stumped now.
I pulled the dizzy out and I triple checked it. The internals are working fine. Installed correctly.
The motor will only adavance 5 degree, no matter where I set it, 15, 20, 25.
I agree the the lash may be out a bit, but what would hinder the advance?
15 degree bushing. 1 light and 1 medium spring. MSD ready to run, with the vacume port plugged off, as I ran it last year.
Any suggestions?
In theory, if the cam was advanced correctly, but the timing gear on the cam was not installed with the dot's lining up, would this have an effect like this?
The cam was installed on a 108 deg. centerline. The motor seams dead, and is running very rich.
Thanks in advance.