I keep hearing that using a flat tapped Cam is a no no. I've got a 1969 sbc with vortec heads so from what I've read it allears as though I would need to use a retro fit roller Cam which are pretty pricey. Tech inspector 1 gave me a great plan above but I don't have the money to do everything he has suggested. If he or others could help me out on some of decisions I need to make it would be appreciated.
The engine in its current state runs good, has consistent compression on all 8 cylinders and burns no oil.
Transmission is a 350 TH recently rebuilt with installation of a Trans Go shift kit. I know I will need to change torque converters. Looking at a 2500?..
Need to change rear end to a 4.10 ? With posi.
Need a Cam that will work between around 1800 to 5500 rpm.
Will be putting on headers with an H cross.
When pulling the heads I will determine if I will look at pistons to see if I need new ones , suggestions on what I need would be appreciated.