Thread: 32 Duece steel frame roadster lt1 engine build

Tweet

Well got custom hairpin rods made and front end is mocked. Still not completely tight and rear end is just mocked up to inspect.
Looking for input to make sure i measure everything right.
Measurementsi need to do-
1. Measure both I beam ends to frame(same location on each side) on both sides to make sure I beam is true.
2. Once I beam is set then measure center of hubs front to rear, then X pattern measurement to each hub to make sure axles are center.
Am I missing anything else for measurements? Caster is around 6-7 degrees right now. Should I have more at this stage or is that something To adjust later after I have a rolling chassis and can factor in ride height?