Hey guys, I just wanted to thank you all for taking the time to give me advice. I am fairly new to the game. But !SOLVED! the problem thanks to all the input... i couldn't be happier.
I had a bit of luck and some good advice.. but if you have been following this you will know I had taken the intake off as a first step to ensure it was sealing. I also mentioned I had under 50 miles on the truck. I may have been over reacting. But the intake was not sealing properly and I was getting a small amount of antifreeze into the oil from the poor seal. I made this post after making sure I sealed the intake 100%.
From day one I had water in oil so during break in of the rings I had this issue( again only 50 miles) the rings were not seating. Here is the lucky part I think. Today I changed the oile to a 30w oil has a last resort before pulling the engine, and actually drove the piss out of it on the highway slowing down and to the floor repeat. Came home hot did a compression test 180 all around. Leak down test came in at 5% AND BEST OF ALL 0 SMOKE. plugs cleaned up basically a miracle.
Now I'm confident I'm good to go and this morning I was rdy to pull the engine. My gut told me it was going to be something simple and it was. And more bright side I learned a shit ton over the last few weeks. Thanks again!