First time post, but view the forum a lot and need a little help from you SBC guys. I have a 1969 SBC 350 ,DH heads, 4bl edlebrock, sitting in my 76 CJ5. Sorry, not your typical hotrod. But I have done a frame off restore, rebulit trans, and alot of work to the jeep. Engine has run great the entire time I have owned it, and I recently installed a new Edlebrock 1406 4bl carb to replace the previous 1406 that was on there (rebuilding and putting on another engine).

The jeep is not a daily driver, but last few times I had it cranked, I was fine tuning my choke/adjustment, etc.), also recently installed a new HEI distributor (little recent background). Wanted to add those two comments in case they are in some way related to sound, but I dont think it is. I took it out recently and heard a light ticking, not a deep knocking, but almost sounds like a exhaust leak sound. Have no exhaust leaks, and at first it sounded like it was coming from my bellhousing area. Ive cranked it and listened in different places, but the more I do it, I find i cant really narrow down a definite location. I hear it under vehicle, between bellhousing and flywheel, checked starter gear clearance, its ok, I somewhat hear it around and in front of the distributor on top of engine. It speeds up and slows down exactly with engine RPMs. Without trying to self diagnose myself like im at the doctor, where are the only possibilites I can come up with. Im hoping you guys can help me cancel out some possibilites, and/or point me in a direction that im not looking or considering. Im mechanically inclined but have not been through every engine's troubleshooting and want to try and limit tearing the whole thing down in search of something that could be simple.

First thought was i may have something loose in bellhousing/clutch/trans, pulled trans off and away from flywheel, still hear sound, so I can cancel that out.

Thought I may have a loose wobbly rocker, took covers off and they all seem to have the same amount of left/right play without any looking suspicious.

Thought it may be something hitting inside of bottom of oil pan, havent pulled it because its muddy and for some reason that gasket is a bi*** to get on and lined up. I also thought it could be oil pump in pan, but dont know much about that particular pump to know how that would fail or make noise. When I crank up, it does have oil pressure, but I have experienced low pressure at low idle (maybe below 20psi). but no erratic up and downs. also thought about where distributor shaft connects to pump, but im guessing if its pumping its ok?

I first noticed it when i was tweeking with my new carb, could I have a bad adjustment or advance or something that could make this sound. Im not real familiar with advance and how carb works with distributor, vacuum, etc. Also could any tweeks have affected timing?

Also, ive considered maybe something with flywheel, but have not pulled it and from just looking at it everything looks ok. Its a manual trans so i dont have torque converter or flex plate. Is there something else on the flywheel between it and engine shaft?

Front pulley on harmonic balancer wobbles a bit, but i think its a warped pulley, and it was like that when I bought vehicle, balancer looks fine.

I want to try and not tear everything apart, when it could be something simple i have not thought of, so Im hoping you guys can help, ask questions, ect. I do know it could be bearings in engine, but dont want to move that direction until i can cancel out the more simple possibilities. And it did start after I was messing with my carb, which I find a little odd, and I can hear it between carb and distributor, so its not just a below engine sound.

Thanks in advance for your help.