yes-yes! I mean measurement in inches.
I checked - crankshaft was undersized to .020, then rusted and in my local workshop grinded\polished to about .040 (but a little bit more in fact). So if have .060 bearing, is it normal to use this type of repair? I mean, if bearings with this size exists, it's ok to use it on stock engine?

Delivery takes ~50 days due to shipping, preparing of Custom papers etc. Spares like crankshaft are very heavy, and it's a not a cheap delivery. Yeah, Finland is near my city, but I call shops - they have only 1pc rms crankshaft, I need to order new crank there - so, it's the same time and money if I'll order from summit. Yeah, it's Russian reality))))