Thread: I broke a main cap. Please advise

Tweet

got to work up to that rate---just counted and with those LTs to change to billet splayed 4 bolters got 32 blocks to do------can't do 5 a day at my age, but I can MULTI-task and run the boring bar same time as the surface grinder or CK10 hone--

Originally Posted by jerry clayton

got to work up to that rate---just counted and with those LTs to change to billet splayed 4 bolters got 32 blocks to do------can't do 5 a day at my age, but I can MULTI-task and run the boring bar same time as the surface grinder or CK10 hone--

yep me to.. i set the rottler up on a bore . deck a block . hone a set of rods out at the same time or valve work grinder /seat machine when set up on a cut. the mill i run the feed very slow on the mill so it just crawls a long.the boring bar is a set it and for get it i never run it in hi speed i tried the carbide they stay will run good in hi speed its a so/so finsh so i run it in low it will peel or 025 to 055 of a cut just as nice with the one edge oe cutters i use the replacement carbide cutter with holder on sleeve facing. i stay around the bar on the start of a cut and walk away from it. less i am cutting a sleeve out .i can only run 3 machines at the same time but not allways that busy. if i doing a valve job or rods. block honing . i try to set up a machine on a cut bore or deck a block