Thread: Street/strip Sb 350 Build Up

Tweet

Originally Posted by tango

HOW would you build up a small block 350 for a street/strip 3500lb auto trans 411gear car ? Must stay with 4" max 30 over bore and 3.48 stroke crank . What Block 1pc or 2pc seal /pistons /heads/camshaft/ intake and carb and ignition sys would you use . And what kind of HP do you think it may have . Thanks for all your ideas

I am sure how to answer the question.
Here is a 350 I built a few weeks ago.
Starting at the top and working done.
A flowed 650 dp,Edelbrock rpm performer,AFR 180 cc heads,Comp. cam XR282HR hyd. roller cam,
GM steel crank,Scat I-beam rods,with SRP flat top pistons.
This engine was installed in a 1981 Camaro with a 4.10 gear and a 3,000 stall.

Originally Posted by erik erikson

I am sure how to answer the question.
Here is a 350 I built a few weeks ago.
Starting at the top and working done.
A flowed 650 dp,Edelbrock rpm performer,AFR 180 cc heads,Comp. cam XR282HR hyd. roller cam,
GM steel crank,Scat I-beam rods,with SRP flat top pistons.
This engine was installed in a 1981 Camaro with a 4.10 gear and a 3,000 stall.

Erik did you ever time this car?My 77 might be close so I was just wondering.Sorry for highjacking the thread.

Originally Posted by camaro77

Erik did you ever time this car?My 77 might be close so I was just wondering.Sorry for highjacking the thread.

No,it has been to cold here.
He will have to wait until next year .