Ok, I bought a chevy 350 four bolt main for 400 bucks and it is bone stock. It is a Vortec motor out of a 99 full size van. It was rebuilt when the sold it to me, but that shouldn't matter all too much as I have some plans for it. First off, I would like to get 350 to 400 hp out of it at least if not more. I am going to carb it and sell the intake that is on it. I want to stroke it and maby bore it too. I have seen stroker kits with forged parts on ebay that look like they should do the trick. I also want to run a turbo charger with 5-10 LBS of boost. I hear you need to knock the compression down to do so and run forged pistons and rods, correct? Also, what kind of gains would I get with the stroker kit? Any suggestions on a cam? I hear that you should go with a mild lift cam if you put a blower of any kind, correct? Also, do you think a 350's rod bearings will hold up to that kind of boost? Any constructive cridisiem is welcome. BTW, I am looking for low end from the powerplant and top end from the turbo. All thoughts are appriciated and thanks.

-Vance