Quote Originally Posted by jeepman1320 View Post
I know that the oil pressure is good, just trying to figure out why there does not seem to be a good steady stream of oil to the rockers. I checked my pickup and it is fine, and with the gasket it is between 3/8' and 1/2" from the pan.
thats ok on pan but1/4 from pan. can suck the pan up to the pick up ...i seen it. how fast your drill going ..your oil pump runs at 1/2 speed of the engine so your drill would have to spin 400 to 500 to realy see whats going on at idle for the push rods to see oil and rpms will go up so will oil and do not forget hot oil flows abit better. if nothing not blue then your getting oil . get a better dist may seal up better in the block help not pass so much oil . look at the primer as well