Quote Originally Posted by rumrumm View Post
I used an aluminum sill plate from Valley Auto Accessories. I have attached a photo. I had to have it clear powder coated because it kept leaving a gray streak on my door panel. I wouldn't be that hard to make one.
Lynn,
I appreciate you posting the picture. I had looked at Valley's sill plate for the OEM '33/'34 and it is a fancy angle piece that forms over the lip of the door sill two or three inches and follows the arc of the bottom of the body, $145 for the pair. That mental picture had me stuck, and I was not seeing that it can be a simple flat piece that can just sit on top of the floor and not roll over the edge. You're right, it would not be that tough to make one.

Quote Originally Posted by 34_40
I picked up a set from an abandoned project, I think they are from Billet Specialties. They are a brushed finished aluminum piece. If I remember right, they also have 3 grooves milled across the top lengthways
34_40,
Thanks for the possible source - I will check out Billet Specialties before I invest time in making something.