Thread: 95 z28 flywheel question

Tweet

Originally Posted by bluenosebully6

Hey im new to this forum but cant get help anywhere else. I have a 95z28 350 lt1 that im almost done rebuilding and I cleaned the tranny today and measured the flywheel runout off the engine and mounted on a brake lathe I cannot find a spec on all data n my machinist doesnt have itin his book as to acceptable runout and max it can be ground does anyone have a difinitive answer I would really appreciate the help

OK, here's how I would proceed:
Call McLeod and talk to any of the engineers there. They will probably be able to tell you without looking anything up.
McLeod Racing - Contact Us
If McLeod won't talk to you, call these guys. I have used them dozens of times in the past and they are spot-on. Don't tell them where you live. If they think you live locally, they will be more likely to talk to you.
Arizona Brake & Clutch Supply in Phoenix, AZ - 602-256-7966

And finally, don't begin any project on a car like this until you have the ORIGINAL FACTORY SERVICE MANUAL in your possession.
1995 Chevy Camaro & Pontiac Firebird Repair Shop Manual Original 2 Volume Set
o
o