I'm working on a chassis built in the sixties. It had a SBC with 4 speed coupled to a GM rear end. I bought it without engine and transmission. It had a drive shaft and I got Ujoints for a '60 Chevy which fit the rear end and driveshaft yokes. I have a TH350 and the tranny yoke is wider spaced so the U joint doesn't fit. Is there a different yoke available or do I have to have the drive shaft redone? I know someone has "been there, done that" so please help. This project was started years ago and I finally get moving on it and plan to fire it up, fill the transmission fluid, get it on a trailer and take it to the exhaust man the by first of the week. Please help while I'm getting to work on it!