Thread: Install 40 rearend
-
01-09-2014 02:27 PM #1
Install 40 rearend
Ok got a 31 model-a with a stock 31 rear found a 40 rear end to replace it can I set that up without the motor and tranny in the car and still get the pinon angle right and what would the right angle be where do I start thanks guy's.
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
01-09-2014 03:23 PM #2
isn't that a torque tube rear end??????
-
01-09-2014 03:32 PM #3
As far as I know.. it should be a torque tube, no pinion angle to worry about.
Unless it's been converted. We'll need model a man to come back with more data.
-
01-09-2014 05:59 PM #4
sorry I'm changing over to open drive my bad.
-
01-09-2014 08:18 PM #5
Your pinion should tilt up at an angle equal to the degree the transmission tilts down. They should be equal, but opposite angles so that the u-joints are traveling at the same angles front & rear.Roger
Enjoy the little things in life, and you may look back one day and realize that they were really the BIG things.
-
01-10-2014 09:35 AM #6
Ok so I guess I need the tranny in the car to what I should do is just put the motor tranny in to be on the safe side.
So, wee Jimmy is sitting at the dining table doing his homework. He turns to his mum, Sheilia, and says, "Maw, would you do this homework for me?" Senga looks at him and says, "No Jimmy, you know...
the Official CHR joke page duel