Thread: Will this raise it??
Threaded View
-
05-10-2011 06:17 PM #11
Ok. I was just out with the 37. I measured my back spacing.. From the edge of the rim to the area where the rotor sits is 3 3/4".. i also looked at the ball joints. I think I can tighten up on them. They are only a few threads above the nut..
John's ride to the cemetery, his beloved Billings OK bus, The Baby Elephant!! Traveling in style!! As his service was starting I couldn't figure out what the music was, heavy on a flute in a jaunty...
John Norton aka johnboy