Hybrid View
-
07-31-2006 03:27 PM #1
Setting the correct degrees on engine and rear end
I will be using parallel leaf springs on my 51 Chevy 3\4 ton and see that 3 degrees down on both trans and engine is the proper setting. What is the best way to determine those degrees? Is there a tool I can use?
-
07-31-2006 04:06 PM #2
Use an angle finder, available at some parts stores, and in all the tool trucks...Yesterday is history, tomorrow is a mystery, Live for Today!
Carroll Shelby
Learning must be difficult for those who already know it all!!!!
-
07-31-2006 05:20 PM #3
cheap angle tool
I have used a plasic angle tool that to me is one of the best bargins going. You can buy these at Sears or any hardware shore. It is a plastic piece that has a manetic wheel in it that when you set it on the york it tells you the degree. The cost about $10.00. Good Luck
We were at a buffet meal and the wife said "That's the fourth time you've gone back for dessert, doesn't that embarrass you?" I said "No, I keep telling them it's for you."
the Official CHR joke page duel