got them out last night, the chain thing worked perfectly.
Now after I get new bearings pressed on, do I just tap the axles back in to those seats with a hammer, or should I pull them on with the retaining plate?
Also, after pulling them out, left inside the housing was a seal with a rubber lip around it. The rubber didn't seem torn up or anything, can I just leave that in or does it have to get replaced too?
On a different note, has anyone ever used "mother's polish" to polish up a cast aluminum intake. I tried some and it didn't seem to work very well. I didn't use a towel, I used a shirt, does that make a difference?