Thread: Holbart 210
Threaded View
-
11-05-2014 05:33 PM #1
Holbart 210
Bought a new welder, in title, was going to go to .023 wire for some sheet metal and it wouldn't feed. went to change the roller around and it is the same on both sides. All my other welders you would just flip the roller around when you changed to smaller wire. Anyone run into this? Going to email them and see what they say, just caught me by surprise.
I had to go to the doctor's this morning. He told me that my sugar was too high so I came home and put it on a lower shelf. I feel better already.
the Official CHR joke page duel