no noise at all i have just tad bit of smoke when i first start it ,, thats because of maybe carb flooding or maybe valve seats ,, after i get it started ,,it goes away ,, now i am worried about the oil pressure after it gets hot i have below 20 my gauge start at maybe 10 small line then you see 20 lbs ,, i do have a HV oil pump that i am going to change along with new oil pan and get rid of the one that is on there now with a 2" piece added to sump i am going to check pickup also too and make sure its close to bottom ( what 3/4 to 1" up ) ,, i thought i could just change bearings ,, a buddy said it would be easy ,, pull all belts , pull plugs do rods first 1 at a time , then loosen all mains a little then them 1 at at ime by turning the motor said they should just come out ,,, now that being said after i look at them maybe they dont need it ,,,,,


thats why i am asking you guys

thanks