Well Dave, I did the gravity bleeding that you suggested and let the thing sit overnight. The fluid level didn't seem to go down at all. I temporarily mounted the reservoir up higher than the mc, took the cap off, tied the pedal fully down, and cracked the bleeder. The fluid probably should have seeped out right?

Ojh, I will go measure on a spare saginaw and double check to make sure the system is shimmed right. I would think that even if it wasn't shimmed right that I should still be able to see the correct amount of movement or is this not true of these to bearings if they are shimmed incorrectly? Also with the limited amount of movement that I do get out of the TO it seems to be moving the pressure plate almost instantly...

Sg4356, you said you have the same setup as I do even the 1" mc and it works fine? Was it real tough to bleed/ get to work properly? How much movement do you get out of the TO?

Thanks for the help guys, this one is really getting me frustrated...