Thread: Bead rollers
Threaded View
-
08-11-2011 05:04 AM #1
Bead rollers
I’m making some progress building the firewall and floor for the 37. I think it would probably be a good idea to roll a few beads in the panels to give them a bit more strength and keep them from oil canning.
I could probably run them by one of the local shops that does HVAC ducting. I’ve also been looking at some of the cheaper ($100-200 range) rollers like Eastwood and Summit sell. I could justify that cost for of one of one of these units and would probably use it occasionally after this project is done.
I was wondering if anyone has experience with one of these cheaper units and if they are just junk or would work OK for occasional light duty work.I've NEVER seen a car come from the factory that couldn't be improved.....
Just before the funeral service the undertaker came up to the very elderly widow and asked "How old was your husband?" '98,' she replied, "two years older than I am." "So there's not much between...
the Official CHR joke page duel