Hybrid View
-
08-09-2010 10:46 AM #1
Here's an old pic of what it used to looks like.....
It doesn't seem to have any bolts to hold it in place though
-
08-09-2010 11:25 AM #2
That is the trouble with buying someone else's car, you never know how they did things or what parts they used. I think he custom made that spreader bar, like I had to do. Are there any holes on the outside of the frame horns, like a bolt went through there to secure the bar?
Don
-
08-09-2010 11:42 AM #3
Hi Rick,
Sorry about the mix up, I should have thought of the spreader bar. Anyway, should be an easy remake. If you don't have a welder or have a friend with one you could buy some SS tubing and make some threaded plugs to tightly fit in the tube and use J B weld or Gorilla Glue to keep the plugs from spinning and bolt it on that way. The plugs need to only keep the bar in place.
Jack.
-
08-09-2010 12:35 PM #4
-
08-09-2010 07:24 PM #5
Rick,
Should work if you can find SS tubing to match the bearing flanges or bearing retainers.
Jack.
-
08-09-2010 07:59 PM #6
I cheated when I made mine and took the easy way out. I first cut a piece of ss tubing to the right length to slip in there, with a little extra room for some large rubber washers slightly bigger than the tube itself (so the tube wouldn't scratch the horns. Then I needed some way to position the tube squarely in the opening, so I took a holesaw that was about the same size as the inside of the ss tube and cut two wooden spacers out of a piece of 2 x 4 lumber.
When I had those cut out I opened up the 1/4 inch hole that the holesaw left in the center to 5/16, shoved the wooden spacers inside the ends of the ss tube (I had to do a little sanding on the perimeter to get a tight fit), and then placed the whole assembly into the opening between the horns. I had drilled a hole in each end, so I passed a piece of all thread rod through the center and put a chrome washer and chrome acorn nut on each end. When I torqued the two nuts down it pulled the horns in slightly, clamping the spreader bar tightly in place.
Now, you may wonder about the pieces of wood not holding up, but I did that job 20 years ago, and when I just redid my T I used the same pieces, they were in mint condition, so no need to do anything different. I guess they stayed dry from being clamped so tight and the rubber washers up against them.
If you drill a hole in each end one of your horns you can do something similar and save a lot of welding and fabrication. Put some masking tape on the painted surfaces of the horns before you drill, keep using larger drill bits until you get the size you need, and the washer will hide any marks left from the drilling. Just a thought on how to easily fix your problem. If you need better pictures of mine I will shoot some if you ask.
This picture below may show what I am describing a little better.
DonLast edited by Itoldyouso; 08-09-2010 at 08:04 PM.
-
08-09-2010 08:04 PM #7
yes, please post some photos if you can
John's ride to the cemetery, his beloved Billings OK bus, The Baby Elephant!! Traveling in style!! As his service was starting I couldn't figure out what the music was, heavy on a flute in a jaunty...
John Norton aka johnboy