Here's the situation: Running a SBC with aftermarket valve covers. Not a major brand. The valve covers didn't have baffles in them but I didn't think too much about it. Got about 3000 miles on the engine and I checked the pvc valve and found it clogged with the nasty water/oil mix. Checked the breather on the other side and it was also coated. I'm not seeing any of the creamy goop on the dip stick. I pulled the valve covers, cleaned them up and cleaned as much of the goop as I could around the rockers and push rods. I fabricated some baffles, replaced the pvc valve and cleaned the breather. Drove the car about 15 miles and checked the pvc valve and although it was not much goop, it still had some on it. The breather was clean. I'll change the oil and filter(have less than 1000 on it since last change). Is there anything else that needs to be done?
Tom