Thread: Horn Contact on GM colum

Tweet

Ok found it, took a couple of pictures for you. Can't stress enough how you should use one of these. It will make life so much easier. This one has a removable threaded end, 9/16 by 18 thread per inch one end, and M14 by 1.5thread per mm on the other. Screw the adapter onto the shaft, tighten the wing nut, pushing the plate down exposing the snap ring. Get the snap ring up out of the groove, (I use an icepick and a small screwdriver.) back off the wingnut and "ta da" it's off. Make your repairs, and put it back together using a reverse proceedure. Sniper