Originally Posted by
oldrodder43
Well, started on the radiator mounts and such. As I mentioned, got a '65-'66 Mustang Radiator from an ebay buy. Looks in good condition and fits very well. I welded two flat pieces of metal to the ends of 1 x 1 tubing, found some reinforced flat rubber, cut two small pieces to go under the flat plates and two smaller ones to go on top of the flat plates. Then bolted all down to the front crossmember in the holes for the original 'A' radiator. Then put small rubber grommets in the holes in the side frames of the radiator, bored holes through the 1 x 1 uprights, then bolted through the uprights, the grommets and the radiator frame. This gives a small amount of vibration isolation through the mounting set-up. I then cut a piece of 1 x 1 and welded it across between the 2 uprights just under the top tank. That makes everything rather solid. Eventually I will bolt the grille shell into the uprights, and I am going to put 3/4 square tubing from those uprights back to the firewall, one each side. These will keep the front assembly secure and give me something to hook the hood top to when the time comes. Pics attached. Enjoy. Perley:)