Thread: One Way To Build A 12 Cylinder Ardun or not

Tweet

Originally Posted by Ken Thurm

Pat-What if you run into porosity pockets when you bore the hole? Do you have any suggestions on the studs if we do run into some tight ones? I'm going to finish taking it apart soon and get it cleaned, I would like to remove them first.

Steve- You just learn from every problem, you know how to put a seal in properly now, I bet you won't forget.
Ken

try bees wax on the block heat up the deck and let the bees wax wick in you my have to do it more then one time to bad you did not live close i would like check it out if you lived by me i have a 500 gal hot tank with the good stuff in it will eat some rust . any one has one out were you are or buy some of that rust eater flip the block upside down in a tray and let the rust eater work from the deck and the under side to .on the porosity it would be nice to have a junk block to cut on .i think if you cut the seat s out and use a bowl hog that tapper will help or just get the block up on a mill and go in on the angle with a end like a 7/16 mill and take what you just need if you use a bowl hog you should center up on a pilot that plug in the guide hole