Pretty good Brad. I posted a post just for these comments. On the truck note, my new Hobart 140 mig welder arrived. I went down to our local welding supply to see about a cart and gas tank. I bought a cart from him to support local business and probably will get the gas cylinder from him too. His prices are a little steep, but lets face it he's local, and he's gotta make a living too, his advice is invaluable. Plus I'll be going there when I run out of stuff and to get tanks refilled. He's a fellow hot rodder whose been doing this stuff since the fifties(though he looks too young to have been around in the 50's! He highly recommends 75/25 Argon /Co2 mixture. Says it cools the metal to where I won't be as likely to warp the sheet metal. I asked about just using flux core but he thought that would be too hot for car sheet metal. His tanks are 160 new, with the gas fill for free on new tanks for the first fill. I've seen them as cheap as 89 on the internet, but by time you throw in shipping, tax and gas it's not too much savings compared to just buying localy. What are your opinions about the temperature thing for welding sheet metal? I just want to patch some small holes in the running boards and repair the rear window frame seem that attaches to the roof. I know Don likes the gas to reduce spatter, but what about temp?