Thread: Throttle linkage
-
12-21-2003 06:18 PM #1
Throttle linkage
I just installed a victor intake and 750 holley double pumper on my 67 fairlane with a 347 stroker. i pulled off the old linkage and put a straight bar from the gas peddle bar to the carb. when i push the gas peddle to full throttle the carb only opens the primaries and barely opens the secondaries. i still have about another inch to go before the secondaries will fully open, but i have no more peddle for this. does anyone have any idea how i can get the secondaries to open or if there is some type of special linkage that i can buy for this?
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
12-22-2003 09:48 AM #2
Move the carburetor end of the linkage to a hole closer to the throttle shaft. this will cause the carb to open more for the same throttle pedal movement. You may have to drill a hole to get it right.Anyone can restore an old car, it takes a man to cut one up
The main function of your little toe is to make sure all the furniture in the house is in the right place.
the Official CHR joke page duel